ORTUR LASER MASTER 3

WHAT ARE THE ADVANTAGES OF THE ORTUR LASER MASTER 3 LASER ENGRAVER?

MUCH LIGHTER LASER MODULE: Integrated air assist, dual fans, foldable focus indicator, all in a weight of 235g which allows it to reach up to 20000mm/min. Just a minute to make it.

THE LATEST SMART SOLUTION: From ORTUR Laser Application Technology Lab, 11th Generation of Laser Motherboard, Smart Laser Firmware V2.0 Series. In a word, know more what you want and easy to use.

10W OUTPUT POWER: This ORTUR laser engraver is equipped with 10W laser module, which can cut 20mm wooden board and 30mm acrylic sheet. Cut through 10mm pine in one pass. It is almost beyond the effect of a 60W CO2 laser.

7 SAFETY PROTECTION SYSTEMS: Security lock (keep key, professional use only), active position protection, bank angle protection, exposure time detection and limitation, voltage and current safety control system, host computer watchdog, emergency stop switch.

 

Laser engraving machine

LOW GRAVITY CENTER STRUCTURE AND EASY INSTALLATION

Pre-packaging makes installation easier. It only takes 10 minutes for a beginner to assemble the machine.

Perfect packaging material, seamless overlap. 70% aluminum + 15% steel + 5% plastic + 5% brass + 5% make the machine more durable than others.

YRR TRANSMISSION SWITCH

SD CARD SLOT

QUIET STEPPER MOTOR

YRR TRANSMISSION SWITCH

There is no need to use the Y-axis motor cable to plug in the YRR, and you can switch between the YRR and Y-axis motors with a switch swap.

SD CARD SLOT

Drag the NC file to the SD card, the device will start working, and you can turn off the computer or mobile phone without worrying about disconnecting, which is more convenient to print for a long time.

QUIET STEPPER MOTOR

Supports each corner of the endless switch to return to the position, the drive current and resolution can be adjusted, and the protection will be blocked.
 
10W output power

MORE ENGRAVING EFFECT

The new laser's 3rd beam combination technology with double compression points can work very well at a high speed of 20000mm/min , saving you more than half the time than other similar brands.

ORTUR

Multiple Safety Protections, Safer to Use!

Laser light emission detection and protection: The system detects the laser on-time and limits it to prevent fire accidents caused by long-term irradiation of the laser in a static state.

USB connection detection and protection: If the USB cable is abnormally disconnected when using the USB cable for online engraving, the system will stop immediately to prevent the engraving machine from running out of control.

Position offset detection and protection: The acceleration sensor detects the position status of the engraving machine in real time. If the machine is found to be offset after engraving, the system will stop immediately and give an alarm to avoid wrong engraving.

Machine inclination detection and protection: The gyroscope sensor detects the real-time angle status of the machine. If the machine is found to have a tilt change or even overturn after engraving, the system will stop immediately to avoid laser irradiation damage and injury elsewhere.

Current and Voltage Detection and Protection: Current and voltage sensors check the voltage and current of the power supply in real time. When abnormal voltage fluctuation or short-circuit current overload is detected, the system will shut down immediately to avoid permanent damage to the engraving machine.

Laser Master 3 laser engraving machine

LASER EXPLORER - PROFESSIONAL APP BUT EASY TO USE

Support SD card/USB/Wi-Fi APP/Access Point offline work.

Support selfie printing, without too many professional parameter settings, shoot directly. Beginners can quickly learn to use them.

Professional APP Laser Explorer that is easy to use, automatic operation guide, beginner-friendly. It can be compatible with iPhone, Android phones, iPad and Android Pad.

location fans